** SAMPLE OUTPUT FROM DEBUG SERIAL PORT ** RomBOOT > Entry: Kernel Loader v4.0.0 [SPI] Sending command: 0xD7 0x00 0x00 0x00 0x0002 [SPI] Device status = 0xBE PHY: LXT972 Autoboot in 3 . 2 . 1 . > >m # ## ## # # ## > > >t console=ttyS0,115200 root=/dev/mtdblock0 rootfstype=yaffs2 mem=64M >spi_read 43080 22400000 200000 Sector protect enabled >e 22400000Uncompressing Linux.................................................. [ 0.000000] Linux version 2.6.24 (root@kbdev-laptop13) (gcc version 3.4.2) #8 [ 0.000000] CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177 [ 0.000000] Machine: KwikByte CAM60 [ 0.000000] Memory policy: ECC disabled, Data cache writeback [ 0.000000] Clocks: CPU 200 MHz, master 100 MHz, main 10.000 MHz [ 0.000000] CPU0: D VIVT write-back cache [ 0.000000] CPU0: I cache: 8192 bytes, associativity 4, 32 byte lines, 64 ses [ 0.000000] CPU0: D cache: 8192 bytes, associativity 4, 32 byte lines, 64 ses [ 0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pa6 [ 0.000000] Kernel command line: console=ttyS0,115200 root=/dev/mtdblock0 roM [ 0.000000] AT91: 96 gpio irqs in 3 banks [ 0.000000] PID hash table entries: 256 (order: 8, 1024 bytes) [ 0.000000] Console: colour dummy device 80x30 [ 0.000000] console [ttyS0] enabled [ 0.080000] Dentry cache hash table entries: 8192 (order: 3, 32768 bytes) [ 0.090000] Inode-cache hash table entries: 4096 (order: 2, 16384 bytes) [ 0.100000] Memory: 64MB = 64MB total [ 0.110000] Memory: 61452KB available (2968K code, 322K data, 116K init) [ 0.110000] SLUB: Genslabs=11, HWalign=32, Order=0-1, MinObjects=4, CPUs=1, 1 [ 0.310000] Mount-cache hash table entries: 512 [ 0.310000] CPU: Testing write buffer coherency: ok [ 0.320000] net_namespace: 64 bytes [ 0.330000] NET: Registered protocol family 16 [ 0.360000] SCSI subsystem initialized [ 0.370000] usbcore: registered new interface driver usbfs [ 0.370000] usbcore: registered new interface driver hub [ 0.380000] usbcore: registered new device driver usb [ 0.420000] NET: Registered protocol family 2 [ 0.430000] Time: pit clocksource has been installed. [ 0.530000] IP route cache hash table entries: 1024 (order: 0, 4096 bytes) [ 0.540000] TCP established hash table entries: 2048 (order: 2, 16384 bytes) [ 0.540000] TCP bind hash table entries: 2048 (order: 1, 8192 bytes) [ 0.550000] TCP: Hash tables configured (established 2048 bind 2048) [ 0.560000] TCP reno registered [ 0.590000] NetWinder Floating Point Emulator V0.97 (double precision) [ 0.600000] audit: initializing netlink socket (disabled) [ 0.600000] audit(0.598:1): initialized [ 0.660000] VFS: Disk quotas dquot_6.5.1 [ 0.660000] Dquot-cache hash table entries: 1024 (order 0, 4096 bytes) [ 0.690000] yaffs Mar 6 2008 10:11:10 Installing. [ 0.700000] io scheduler noop registered [ 0.700000] io scheduler anticipatory registered [ 0.700000] io scheduler deadline registered [ 0.710000] io scheduler cfq registered (default) [ 0.760000] atmel_usart.0: ttyS0 at MMIO 0xfefff200 (irq = 1) is a ATMEL_SERL [ 0.790000] RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 bloce [ 0.800000] loop: module loaded [ 0.840000] MACB_mii_bus: probed [ 0.840000] eth0: Atmel MACB at 0xfffc4000 irq 21 (##:##:##:##:##:##) [ 0.850000] eth0: attached PHY driver [Generic PHY] (mii_bus:phy_addr=ffffff) [ 0.860000] Driver 'sd' needs updating - please use bus_type methods [ 0.870000] SCSI Media Changer driver v0.25 [ 0.870000] Driver 'ch' needs updating - please use bus_type methods [ 0.900000] NAND device: Manufacturer ID: 0x2c, Chip ID: 0xd3 (Micron NAND 1) [ 0.910000] AT91 NAND: 8-bit, HardwareSYN ECC [ 0.910000] Scanning device for bad blocks [ 1.070000] Creating 1 MTD partitions on "at91_nand": [ 1.080000] 0x00000000-0x40000000 : "nand_fs" [ 1.090000] atmel_spi atmel_spi.0: Atmel SPI Controller at 0xfffc8000 (irq 1) [ 1.100000] mtd_dataflash spi0.0: AT45DB642x (8448 KBytes) [ 1.100000] Creating 4 MTD partitions on "spi_flash": [ 1.110000] 0x00000000-0x00001080 : "BOOT1" [ 1.120000] 0x00001080-0x00043080 : "BOOT2" [ 1.120000] 0x00043080-0x0027fe40 : "kernel" [ 1.130000] 0x0027fe40-0x00840000 : "file system" [ 1.140000] at91_ohci at91_ohci: AT91 OHCI [ 1.140000] at91_ohci at91_ohci: new USB bus registered, assigned bus number1 [ 1.150000] at91_ohci at91_ohci: irq 20, io mem 0x00500000 [ 1.220000] usb usb1: configuration #1 chosen from 1 choice [ 1.230000] hub 1-0:1.0: USB hub found [ 1.230000] hub 1-0:1.0: 1 port detected [ 1.350000] Initializing USB Mass Storage driver... [ 1.350000] usbcore: registered new interface driver usb-storage [ 1.360000] USB Mass Storage support registered. [ 1.360000] usbcore: registered new interface driver libusual [ 1.370000] mice: PS/2 mouse device common for all mice [ 1.380000] i2c /dev entries driver [ 1.380000] TCP cubic registered [ 1.390000] NET: Registered protocol family 1 [ 1.390000] NET: Registered protocol family 17 [ 1.400000] RPC: Registered udp transport module. [ 1.410000] RPC: Registered tcp transport module. [ 1.410000] drivers/rtc/hctosys.c: unable to open rtc device (rtc0) [ 1.420000] yaffs: dev is 32505856 name is "mtdblock0" [ 1.420000] yaffs: passed flags "" [ 1.430000] yaffs: Attempting MTD mount on 31.0, "mtdblock0" [ 35.150000] VFS: Mounted root (yaffs2 filesystem) readonly. [ 35.160000] Freeing init memory: 116K Mount failed for selinuxfs on /selinux: No such device INIT: version 2.86 booting Starting the hotplug events dispatcher: udevd. Synthesizing the initial hotplug events...done. Waiting for /dev to be fully populated...done. Setting the system clock. Cannot access the Hardware Clock via any known method. Use the --debug option to see the details of our search for an access method. * Unable to set System Clock to: Thu Jan 1 00:00:46 UTC 1970 Activating swap...done. Setting the system clock. Cannot access the Hardware Clock via any known method. Use the --debug option to see the details of our search for an access method. * Unable to set System Clock to: Thu Jan 1 00:00:47 UTC 1970 Cleaning up ifupdown.... Loading kernel modules...FATAL: Could not load /lib/modules/2.6.24/modules.dep:y Checking file systems...fsck 1.40.6 (09-Feb-2008) done. Setting kernel variables...done. Mounting local filesystems...done. Activating swapfile swap...done. Setting up networking.... Configuring network interfaces...done. Starting portmap daemon.... Starting NFS common utilities: statd. Setting console screen modes and fonts. [ 57.840000] eth0: link up (100/Full) INIT: Entering runlevel: 2 Starting system log daemon.... Starting kernel log daemon.... Starting OpenBSD Secure Shell server: sshd. Starting MySQL database server: mysqld . .. Checking for corrupt, not cleanly closed and upgrade needing tables.. Starting PostgreSQL 8.3 database server: main. Starting MTA: exim4. Starting NFS common utilities: statd. Starting internet superserver: inetd. Starting deferred execution scheduler: atd. Starting periodic command scheduler: crond. Starting web server: apache2. Debian GNU/Linux lenny/sid kb926x-dev ttyS0 kb926x-dev login: